Innokin iTaste CLK E-cigarette Kit

Innokin iTaste CLK Kit Full Details

• Standby current:

  50uA max

• Over-Discharge Protection:

  The iTaste CLK monitors the battery voltage and will automatically turn off when the battery is discharged.

• Maximum output current:

  3.5A

• Maximum output wattage:

  15W

• Clearomizer Resistance:

  1.2 ohm (minimum), recommendation 2.5Ohm.

• Battery:

  Built-in 800 mAh polymer Li-Ion rechargeable battery.

• Charging:

  420mA-4.2V max 350 mA

• Short Circuit Protection:

  0.6 +/-0.2 ohm

• Variable Voltage:

  The rotational wheel adjusts voltage in the following increments: 3.5, 3.8, 4.0, 4.3, 4.5, 4.8, 5.0

• The red LED will blink six times and turn off if the rotational wheel is not in place.
• To set your desired voltage turn the rotational wheel to the left or right until you hear an audible click. When adjusting the voltage with the rotational wheel always check to ensure the wheel is set to your desired voltage.

• Short Circuit/Atomizer Protection:

  Short Circuit/Atomizer Protection helps protect the iTaste CLK against faulty atomizers.

• Over-Discharge Protection:

  The iTaste CLK monitors the battery voltage and will automatically turn off when the battery is discharged.

  • Green

    = Fully Charged (When it is fully charged the LED light will turn green and power off.)

  • Yellow

    = Half Discharged

  • Red

    = In need of charging

• Superior Battery Life:

  The iTaste CLK e-cigarette features a built-in 800 mAh polymer Li-Ion rechargeable battery.

• 510 Threaded:

  The iTaste CLK is threaded to accept 510 accessories, including the iClear10, iClear16 and iClear30 clearomizers.

• ON/OFF Battery Switch:

  Press the power button three times in rapid succession to turn on the iTaste CLK!. Once the iTaste CLK! is On hold down the power button to activate the atomizer and vape. When the iTaste CLK! is not in use press the power button three times in succession to power off the iTaste CLK! Advanced Personal Vaporizer. Always power off the iTaste CLK! Advanced Personal Vaporizer when it is not being used, or when it is going to be stored in a pocket, bag or purse.

• Package Contents
• 1 x iTaste CLK 800mAh Polymer Li-ion Intelligent Rechargeable Battery
• 1 x Micro USB Retractable Cable
• 1 x Beauty Ring
• 1 x Instruction Manual
• 1 x Lanyard
• 1 x iClear16D Clearomizer
• +
• 1 x Free 10ml Cherry flavour 12mg e-liquid

Innokin iTaste CLK Kit Instructions

• To POWER ON the iTaste CLK! :

  Pressing the power button three times in rapid succession will power on the iTaste CLK! Advanced Personal Vaporizer. The main LED light will blink from red to yellow to green, after which the iTaste CLK! Advanced Personal Vaporizer will enter standby mode. The final color of the LED will indicate the current power level. When the iTaste CLK! Advanced Personal Vaporizer has been powered on, hold the button down to activate the unit. The color of the LED when the button is pressed indicates the current power level.

• Low Voltage Warning

  The Red LED will continue blinking for eight seconds when battery capacity is lower than 3.3V and the iTaste CLK! Advanced Personal Vaporizer will automatically power off.

• Battery Capacity Display

  The main LED light will display green to indicate full battery charge, yellow to indicate half capacity and red to indicate immediate charging is required.

• 
• To POWER OFF the iTaste CLK! :

  Press the power button three times in succession to power off your iTaste CLK! Advanced Personal Vaporizer.

• 
• Short Circuit

  The Red LED light will remain lit for five seconds if a load short circuit is detected, after which no vapor will be produced. Check the device carefully to determine the cause of the short circuit. If the cause of the short circuit cannot be detected contact your authorized Innokin vendor for more information.

• To assemble your iTaste CLK! Advanced Personal Vaporizer

  1) Carefully refill your clearomizer to a correct level.

• 
• 2） Screw the filled iClear16D dual coil clearomizer onto battery
• 
• Congratulations! Your iTaste CLK! is now ready to be vaped and enjoyed.
• To charge the iTaste CLK! battery with the provided Micro USB cable use a high quality wall socket adapter or a computer USB port.
• The iTaste CLK! is a passthrough device and can be vaped as it is charging.
• The main iTaste CLK! battery LED power light will blink from red to yellow to green, after which the iTaste CLK! battery will enter standby mode. The final LED color will indicate the current power level. The main LED light will display green to indicate a full battery charge, yellow to indicate power is at half capacity and red to indicate immediate charging is required.
• RED

  = battery voltage is lower than 3.6V

• YELLOW

  = battery voltage is around 3.6V-3.75V

• Green

  = battery voltage is higher than 3.75V

• PLEASE NOTE:

  The Red LED will blink for eight seconds when battery capacity is lower than 3.3V and the iTaste CLK! will automatically power off. If a load short circuit is detected the Red LED light will stay lit for five seconds, after which no vapor will be produced. If the RED light remains lit for more than five seconds, and your device is within the 3 month warranty period, please contact your authorized Innokin vendor for warranty details

• When the iTaste CLK! battery is fully charged the LED light on the firing button will turn green and power off